How to Flash the Tecno Spark 4

0

If you're reading this post then you own and looking for how to download and flash Tecno Spark 4 which is bricked, malfunctioning or locked, In this post, I will give the requirements, stages, and measures to take before flashing your device.

You might encounter soft brick, hard brick, boot loop, or other software related problems on this device model and would like to flash the phone with either stock ROM to fix it.

In this content, I will provide the instructions and important steps to take in downloading and flashing the official firmware of the Tecno Spark 4.


Before kicking off I would like to let you know that if your device is faulty but can still boot to the home screen then it's important to take the backup of your important files, use the Wondershare mobile software to backup your device files, SMS, contacts, messages and call logs.


How to flash the Tecno Spark 4 with stock ROM/Official firmware

Pre-requisites

  • Make sure your Tecno Spark 4 is well charged.
  • Get a PC or Laptop
  • Take Device Backup - Backup Android Phone files without Root.
  • Mediatek Drivers Installation
  • Firmware/Stock ROM/Flash file Download
  • Flashing the Firmware

Installing Mediatek VCOM drivers

To flash the Tecno Spark 4 MTK VCOM drivers must be installed, else the phone cannot connect to the PC for flashing.

If you are a Windows 8 or 10 user then you'll be required to disable driver signature enforcement before installing MTK VCOM drivers. Guide to disable driver signature enforcement. Win 8 | Win 10


Stock ROM/Firmware/Flash Download

In this step, you will be required to download the stock ROM/firmware/flash file for Tecno Spark 4 . Download the firmware that corresponds with your device build no.

List of Tecno Spark 4 stock ROMs/firmware/flash files

  • Spark 4 KC2 (KC2-H6113AI-P-190925V186) Download
  • Spark 4 KC2J (KC2j-H6113BJ-P-190826V163) Download
  • Spark 4 KC2J (KC2j-H6113BJ-P-190925V190) Download
  • Spark 4 KC8 (KC8-H6110LMN-P-191006V111) Download

Download Agent (DA) for flashing Tecno Spark 4

Tecno Spark 4 has a Secured Boot which requires DA (Download Agent) DA is a file that enables the flash tool to connect with the secured boot phone.

Also, take note DA file is not generic like it was on older Mediatek phone, if your device is secured boot then you are required to provide the DA for your phone model.


Disclaimer! J5 Tech will not be responsible for any damage that may happen while/after following this guide.


Instructions to flash the Tecno Spark 4

Guide to flash the Tecno Spark 4 firmware using Sp flash tool

Remember you previously downloaded the firmware so the link above is a video and a written guide that explained how to flash the Tecno Spark 4 with the firmware.

So that’s it, this was all you need to flash your phone. I hope that you found this guide useful.

In case, if you still have some problems or queries, feel free to post them in the comments section down below.

Post a Comment

0Comments
Post a Comment (0)